Time to fabricate/prototype our awesome catch can design! We would be using our in-house fabrication equipment and our 3D printer to develop a plastic and metal prototype.
We began … Continue Reading ››
What does one do with a blown Subaru EJ20? We asked this question on one of our social media outlets and had a ton of responses. This included a coffee table, flower pot, speaker system, stove, and even a boat anchor. After spinning a few rod bearings during … Continue Reading ››
We recently decided to take a look at the issues surrounding the frequent radiator failures for the 6.4L, check out our findings below!
After identifying the radiator as a common failure point … Continue Reading ››
An inside look at the engineering of Mishimoto products.