Time to see how efficient our cooler design is! We would be pulling our test truck onto our Dynojet to collect the data needed to evaluate the intercooler fully. Check out the conditions of our testing procedure below!
Testing ConditionsVehicle: 2010 Dodge Ram 6.7L Cummins, Automatic Transmission, Performance Air Intake, Exhaust Modifications, Tune
Ambient Temperature: 70°F–76°F
Sensors: PLX Devices with Temperature sensors on both the intercooler inlet and outlet
Process: 6th-gear pulls from 1,800 rpm to 3,200 rpm, … Continue Reading ››
Time to install our prototype radiator into a test vehicle to make sure that it fits perfectly. Luckily, we were able to check fitment on the same donor vehicle we used for our last round of testing. Once the truck rolled into the shop, we quickly installed our prototype radiator shown at the end of our last post. Check out a few shots taken during the installation process!
Continue Reading ››
Our prototype intercooler is ready to go! Let’s take a quick peek at what our engineers designed!
First impressions, this cooler is massive compared to the factory unit. Our engineers weren’t kidding when they mentioned that the size increase would be … Continue Reading ››
Now that we had our project objectives outlined, we could bring in a vehicle to begin the first stage of product development. After checking with our local contacts, we were able to locate the 2010 6.7L you see below!
A big thank you to the owner of this truck! Take a look under the hood. This truck was equipped with some … Continue Reading ››
Time to design an intercooler! Our first step toward this goal was to remove the intercooler so we could collect all the data points we needed. All front-end components were then removed from the truck to provide access.
Take a look at the … Continue Reading ››
An inside look at the engineering of Mishimoto products.